Table of Contents
Does the Onkyo receiver have a reset button?
Hold v “VCR/DVD” button and press with another finger v “In standby” button. Watch v display. You should see “Clear” on recipient display before This goes into standby mode. Release buttons.
Why is my Onkyo receiver not working?
Incorrect settings on your Receiver Onkyo may result in no sound. The digital input must be set to “Auto”. Select the correct digital input source. Press the “Muting” button on the remote control to turn on Receiver Onkyo. Check the inputs and outputs to make sure they are properly connected to recipient.
How to reset the Onkyo TX sr373 receiver?
how do you make a factory reload on the Onkyo Texas–cf373?
To do this, use the controls on the front panel.
Why is there no sound from my receiver?
Unite v cables securely v correct input and output terminals of your recipient, speakers and input devices. Make sure v Input Devices audio playback. Make sure v VOLUME or MASTER VOLUME knob of your AV Recipient VOL MIN is not set. Make sure headphones are not connected to your recipient or input device.
How to fix the receiver in protective mode?
How to fix amplifier protection mode?
Steps to fix protection mode
Why is my receiver going into protection mode?
your stereo system recipient is an switch to protection mode insofar as recipient has an internal short circuit, the speaker is defective, or the speaker wiring is damaged. probleme.g. incorrect wire size or bad connections. If recipient turns off after a speaker is connected, the speaker’s wiring or the speaker itself has problem.